Description:
Enables or disables the IP phone to set up a conference call using a new line key when
multiple line keys are associated with an account.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will place a new call using the current line key when
pressing the Conf/Conference soft key.
If it is set to 1 (Enabled), the IP phone will place a new call by automatically selecting a new
line key (the corresponding line key is not seized) when pressing the Conf/Conference soft
key. If all line keys are seized, the current line key will be used.
Note: The number of the line keys is determined by the value of the parameter
“account.X.number_of_linekey”. The value configured by the parameter
“account.X.phone_setting.call_appearance.conference_via_new_linekey” takes precedence
over that configured by this parameter. It is not applicable to SIP-T19(P) E2/CP860/CP920 IP
phones.
Web User Interface:
None
Phone User Interface:
None
Per-Line Parameters:
Two parameters listed in the above table have a per-line equivalent that you can configure. The
per-line parameters are listed in the following table. Note that the per-line parameter takes
precedence over the global parameter.
X stands for the serial number of the account.
X ranges from 1 to 16 (for SIP-T54S/T48G/T48S/T46G/T46S/T29G)
X ranges from 1 to 12 (for SIP-T52S/T42G/T42S)
X ranges from 1 to 6 (for SIP-T41P/T41S/T27P/T27G)
X ranges from 1 to 3 (for SIP-T40P/T40G/T23P/T23G)
X ranges from 1 to 2 (for SIP-T21(P) E2)
To Next Page
Loading...
