Yealink SIP-T21 E2

Configuring Basic Features
311
areas in one country. When entered numbers match the predefined area code rule, the IP
phone will automatically add the area code before the numbers when dialing out them. IP
phones only support one area code rule.
Procedure
Area code rule can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Create the area code rule and
specify the maximum and
minimum lengths of entered
numbers.
Parameters:
dialplan.area_code.code
dialplan.area_code.min_len
dialplan.area_code.max_len
dialplan.area_code.line_id
Web User Interface
Create the area code rule and
specify the maximum and
minimum lengths of entered
numbers.
Navigate to:
http://<phoneIPAddress>/servlet?
p=settings-areacode&q=load
Details of Configuration Parameters:
Parameters
Permitted Values
Default
dialplan.area_code.code
String within 16 characters
Blank
Description:
Configures the area code to be added before the entered numbers when dialing out.
Example:
dialplan.area_code.code = 0592
Note: The length of the entered number must be between the minimum length configured
by the parameter “dialplan.area_code.min_len” and the maximum length configured by the
parameter “dialplan.area_code.max_len”. It works only if the values of the parameters
“dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
Web User Interface:
Settings->Dial Plan->Area Code->Code
Phone User Interface: