Yealink SIP-T21 E2

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
404
Parameters
Permitted Values
Default
X is equal to 1 (for SIP-T19(P) E2/CP860/CP920)
Example:
account.1.anonymous_call_offcode = *73
Note: It works only if the value of the parameter “account.X.send_anonymous_code” is set
to 0 (Off Code).
Web User Interface:
Account->Basic->Send Anonymous Code->Off Code
Phone User Interface:
Menu->Features->Anonymous->Line X->Off Code
To configure anonymous call via web user interface:
1. Click on Account->Basic.
2. Select the desired account from the pull-down list of Account.
3. Select the desired value from the pull-down list of Local Anonymous.
4. Select the desired value from the pull-down list of Send Anonymous Code.
5. (Optional.) Enter the anonymous call on code in the On Code field.
6. (Optional.) Enter the anonymous call off code in the Off Code field.
7. Click Confirm to accept the change.
To configure the anonymous call via phone user interface:
1. Press Menu->Features->Anonymous.
2. Select the desired line and then press the Enter soft key.
3. Press or , or the Switch soft key to select the desired value from the Local
Anonymous field.
4. (Optional.) Press or , or the Switch soft key to select the desired value from the
Send Anony Code field.
5. (Optional.) Enter the anonymous call on code in the On Code field.
6. (Optional.) Enter the anonymous call off code in the Off Code field.
7. Press the Save soft key to accept the change.