Yealink SIP-T21 E2

Configuring Basic Features
483
the More soft key to see the DPickup soft key). As shown below:
Note
Procedure
Directed call pickup can be configured using the following methods.
Central Provisioning
(Configuration File)
<MAC>.cfg
Configure the directed call pickup
code on a per-line basis.
Parameter:
account.X.direct_pickup_code
Configure directed call pickup
features on a phone basis.
Parameters:
features.pickup.direct_pickup_enable
features.pickup.direct_pickup_code
<y0000000000xx>.cfg
Assign a directed call pickup key.
Parameters:
linekey.X.type/
programablekey.X.type/
expansion_module.X.key.Y.type
linekey.X.line/ programablekey.X.line/
expansion_module.X.key.Y.line
linekey.X.value/
programablekey.X.value/
expansion_module.X.key.Y.value
linekey.X.label/
programablekey.X.label/
expansion_module.X.key.Y.label
linekey.X.shortlabel
It is recommended not to configure the directed call pickup key and the DPickup soft key
simultaneously. If you do, the directed pickup key will not be used correctly.