Applications) feature on the IP phone.
0-Disabled
1-Enabled
Note: It is not applicable to SIP-T19(P) E2/CP860 IP phones. If you change this parameter,
the IP phone will reboot to make the change take effect.
Web User Interface:
Features->Remote Control->CSTA Control
Phone User Interface:
None
To configure uaCSTA feature via web user interface:
1. Click on Features->Remote Control.
2. Select the desired value from the pull-down list of the CSTA Control.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click OK to reboot the phone.
To Next Page
Loading...
