Configuring Basic Features
35
The auto redial feature allows the IP phone to redial the dialed out number
automatically when the dialed number is busy. You can set the times of auto redial and
the seconds to wait between redial attempts. The IP phone will retry as many times as
configured till the dialed number is no longer busy.
Procedure
Auto redial can be configured using the configuration files or locally.
To configure the auto redial via web user interface:
1. Click on Phone->Features->General Information >>.
2. Select Enabled from the pull-down list of Auto Redial.
3. Enter the desired value in the Auto Redial Interval field.
4. Enter the desired value in the Auto Redial Times field.
5. Click Confirm to save the change.
The DND feature allows the IP phone to reject the incoming calls on a specific line or on
all lines. The incoming calls are logged as missed calls while the DND is enabled. You
can enable the DND on the phone or on the server. You can enable/disable the DND
feature for the phone, or you can customize the DND feature for each account or all
accounts. The following describes the DND key modes:
Phone (default): When the DND key mode is ―phone‖, it means the DND feature
applies to all accounts.
Custom: When the DND key mode is ―custom‖, it means that you can configure the
DND feature for each account or all accounts.
The DND enabled on the phone disables the local Call Forward settings. The DND
enabled on the IP phone may be overridden by the server settings. You can configure a
DSS key to be DND key. Press the DND key on the IP phone to toggle the DND mode.
To Next Page
Loading...
Need help?
General