Yealink T54W

MetroNet -Yealink Desk Phones T54W & T57W User Guide
Version 1.0
10.25.2021
41
3.14.3.2 Performing a Blind Transfer Using a Transfer Key
After you have set a Transfer key with a specific contact, you can perform a blind transfer by
using it.
Before You Begin: Confirm with your system administrator that the transfer mode has set to
perform a blind transfer.
Procedure
1. Press the Transfer key during a call.
• The call is transferred to the specific contact directly.
3.14.3.3 Performing a Semi-Attended/Attended Using a Transfer Key
After you have set a Transfer key with a specific contact, you can perform a semi-
attended/attended transfer by using it.
Before You Begin: Confirm with your system administrator that the transfer mode has set to
perform attended transfer.
Procedure
1. Press the Transfer key during a call.
• The phone calls the specific contact first. Wait until you hear the ring back tone or until
the contact answers the call.
2. Press the Transfer key again.
3.14.3.4 Performing a Call Transfer by Selecting a Transfer Mode
During the call, you can press the Transfer key to select a transfer mode.
Before You Begin: You need to set a Transfer key for a specific contact. Check with your system
administrator to find out if this call transfer feature is available on the phone.
Procedure
1. Press the Transfer key during a call. The phone screen is shown below:
Figure 17. Transfer Selections