Yealink VC Series Administrator's Guide

Administrator‘s Guide for Yealink Video Conferencing Systems
72
Codec
Algorithm
Bit Rate
Sample Rate
Reference
PCMU
G.711
64 Kbps
8 Ksps
RFC 3551
PCMA
G.711
64 Kbps
8 Ksps
RFC 3551
Codecs parameters on the system are described below:
Parameter
Description
Configuration Method
Enable Codecs
Specifies the enabled codecs for
the system to use.
Note: All support codecs are
enabled on the system by
default.
Web User Interface
Disable Codecs
Specifies the disabled codecs for
the system not to use.
Web User Interface
To configure codecs via the web user interface:
1. Click on Account->Codec.
2. Select the desired codec from the Disable Codecs or the Enable Codecs column.
3. Click or to disable or enable the selected codec.
4. Select the desired codec from the Enable Codecs column, and click or to
adjust the priority of the selected codecs.
5. Click Confirm to accept the change.
The system supports SIP and H.323 protocols for incoming and outgoing calls. The
default call type on the system is Auto, the system preferentially uses the H.323 protocol
to place calls. If there is no available H.323 account on the system, the system will switch
to the SIP protocol for placing calls. You can specify the desired protocol for the system

Yealink VC Series Specifications

General

Brand	Yealink
Model	VC Series
Category	Conference System
Language	English