Yealink VC Series - Call Type

Configuring Call Preferences
73
to place calls. Ensure the remote system supports the same ptotocol.
The call type parameter on the system is described below:
Parameter
Description
Configuration Method
Call Type
Specifies the preferred call type
for placing calls.
 Auto—the system
automatically uses the
available call type.
 SIP—the system uses the SIP
protocol for placing calls.
 H.323—the system uses
H.323 protocol for placing
calls.
Default: Auto
Remote Control
Web User Interface
To configure call type via the web user interface:
1. Click on Setting->Call Features.
2. Select the desired value from the pull-down list of Call Type.
3. Click Confirm to accept the change.
To configure call type via the remote control:
1. Select Menu->Call Features ->Call Type.
2. Select the desired value from the pull-down list of Call Type.
3. Press the Save soft key to accept the change.