Configuring System Settings
167
2. Select desired value from the pull-down list of Remote Control Enabled.
3. Click Confirm to accept the change.
Site Name
When the system is idle, the site name is displayed on the status bar of display device and video
conferencing phone. You can make an IP address call to the far site, the site name will be
displayed on the display device of the far site. Site name can consist of letters, numbers or
special characters. You can configure the site name of the system via the remote control or web
user interface.
The site name parameter is described below:
Configures the site name of the
system.
Valid values: String within 64
characters
Default:
For VC400: Yealink VC400
For VC120: Yealink VC120
Remote Control
Web User Interface
To configure the site name via web user interface:
1. Click on Setting->General.
To Next Page
Loading...
