Configuring System Settings
219
2. Select the desired value from the pull-down list of USB Enable.
3. Click Confirm to accept the change.
Video Recording
When the system is idle, you can record local video via the remote control. During a call, the
video and presentation which are shown on the display device can be recorded via the remote
control and video conferencing phone.
Before recording video, you need to insert a USB flash drive to the USB port on the
VC400/VC120 Codec to store recorded video. Make sure the USB feature is enabled.
The video recording parameters on the system are described below.
Enables or disables the video
recording feature on the system.
Default: Enabled
If it is set to Disabled, you cannot
record video.
Enables or disables the system to
start recording automatically once a
call is established.
Default: Disabled.
To Next Page
Loading...
