Administrator’s Guide for Yealink Video Conferencing Systems
50
To configure DHCP via web user interface:
1. Click on Network->LAN Configuration.
2. In the IPv4 Config block, mark the DHCP radio box.
3. (Optional.) Enter the host name of the system in the Host Name field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click Confirm to reboot the system immediately.
To configure DHCP via the remote control:
1. Select Menu->Advanced (default password: 0000) ->Internet Configuration->IPv4.
2. Check the DHCP checkbox.
3. Press the Save soft key to accept the change.
The display device prompts “Reboot now?”.
4. Select OK to reboot the system immediately.
Static DNS
Even though DHCP is enabled, you can manually configure the static DNS address(es).
Parameters of static DNS on the system are described below:
Triggers the static DNS feature to on
To Next Page
Loading...
