Yealink VC120 - Page 65

Configuring Network
49
Parameter
DHCP Option
Description
Protocol
Servers
client by IP address.
Vendor-Specific
Information
43
Identifies the vendor-specific information.
Vendor Class
Identifier
60
Identifies the vendor type.
TFTP Server
Name
66
Identifies a TFTP server when the 'name' field in
the DHCP header has been used for DHCP
options.
Bootfile Name
67
Identifies a bootfile when the 'file' field in the
DHCP header has been used for DHCP options.
For more information on DHCP options, refer to
http://www.ietf.org/rfc/rfc2131.txt?number=2131 or
http://www.ietf.org/rfc/rfc2132.txt?number=2132 .
To make the system gather network settings via DHCP options, you need to contact your
network administrator to configure the DHCP server properly.
DHCP feature parameters on the system are described below:
Parameter
Description
Configuration Method
DHCP
Enables or disables the system to
obtain network settings from the
DHCP server.
Default: Enabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Host Name
Configures the host name of the
system.
Default: Blank
Note: When the system broadcasts
DHCP DISCOVER messages, it will
report the configured host name to
the DHCP server via DHCP option
12. Host name is optional, so it is not
a mandatory configuration item. For
more information, contact your
network administrator.
If you change this parameter, the
system will reboot to make the
Web User Interface