Yealink VC120 - Page 291

System Maintenance
275
Parameter
Description
Configuration Method
change take effect.
To configure SNMP via web user interface:
1. Click on Network->Advanced.
2. In the SNMP block, select Enabled from the pull-down list of Active.
3. Enter the SNMP port in the Port field.
4. Enter the IP address or domain name of the SNMP server in the Trusted Address field.
Multiple IP addresses or domain names should be separated by spaces.
5. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
6. Click Confirm to reboot the system immediately.