Yealink VC120 - Page 69

Configuring Network
53
 Gateway: A gateway is a network point that works as an entrance to another network.
 Primary DNS /Secondary DNS: Domain Name System (DNS) servers translates domain
names (for example: www.example.com), which can be easily memorized by humans, to
the numerical IP addresses (192.168.1.15) needed for the purpose of computer services
and devices worldwide.
Network parameters need to be configured manually on the system are described below.
Parameter
Description
Configuration Method
Mode (IPv4/IPv6)
Configures the IP address mode.
Default: IPv4
Note: If you change this parameter,
the IP phone will reboot to make the
change take effect.
Remote Control
Web User Interface
Static IP
Enables or disables the system to
use manually configured network
settings.
Default: Disabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
IP Address
Configures the IP address assigned
to the system.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Subnet Mask
Configures the subnet mask
assigned to the system.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Gateway
Configures the gateway assigned to
the system.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Static DNS
Triggers the static DNS feature to on
Remote Control