Yealink VC120 - Page 73

Configuring Network
57
IPv6 Network parameters need to be configured manually on the system are described below.
Parameter
Description
Configuration Method
Mode (IPv4/IPv6)
Configures the IP address mode.
Default: IPv4
Note: If you change this parameter,
the IP phone will reboot to make the
change take effect.
Remote Control
Web User Interface
Static IP
Enables or disables the system to
use manually configured IPv6
network settings.
Default: Disabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
IP Address
Configures the IPv6 address
assigned to the system.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
IPv6
prefix((0~128)
Configures the IPv6 prefix.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Gateway
Configures the IPv6 default gateway.
Default: Blank
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Static DNS/Static
IPv6 DNS
Triggers the static IPv6 DNS feature
to on or off.
Default: Off
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
DNS Primary
Server/Primary
Configures the primary IPv6 DNS
server.
Remote Control
Web User Interface