TA400/800 User Manual
13/64
The Caller ID string used when this user calls
another user.
Choose a VoIP server, where the account will be
registered.
User name provided by VoIP server.
Authentication name provided by VoIP server.
Authentication password provided by VoIP
server.
Provided by VoIP server. Keep this field blank if
not needed.
The account will be allowed to make outbound
calls according to the selected template.
Defines the expected DID number if this trunk
passes DID on incoming calls. Leave this field
blank to match calls with any or no DID info.
Select whether to use Hotline or not. Hotline is
disabled by default. If this feature is enabled, the
system will dial out the hotline number
automatically after off-hook.
Set the number to dial out automatically after
off-hook.
Define how long to make Hotline take effect after
you pick up the phone.
If the option ―Send Hook Flash Event‖ is set to
―Yes‖, when pressing the flash key on the analog
phone during an active call. TA will send a SIP
DTMF flash event to the VoIP server. It can be
an interoperation with a FXO gateway which is
used for informing FXO gateway to generate the
flash signal to the CO line.
Sets the minimum time the phone is on hook
before being detected as a hook flash.
Sets the maximum flash time.
Setup the max cull duration for every call of this
user, but it’s only valid for outbound calls.
Note: this setting will not be valid for internal
calls.
Echo Cancellation Setting
To disable or enable echo cancellation. If the line
is used to connect POS machine, it is suggested
that echo cancellation is disabled.
To Next Page
Loading...
Need help?
General
