TA400/800 User Manual
40/64
HTTPS web access, it is disabled by default, and you can enable
it to get safer web access.
VLAN Settings
VLAN (Virtual Local Area Network) is a group of hosts with a common set of
requirements, which communicate as if they were attached to the same broadcast
domain, regardless of their physical location.
A VLAN is a broadcast domain created by switches. This means the VLAN is
configured on switches, layer 3 switches. Note that some of the switches don’t
support VLAN.
Note:
TA400/800 acts as a VLAN client, a 3-layer switch is needed.
Figure 9-5 VLAN Settings
Please follow the steps below to set up VLAN on TA400/800.
Step1. Create VLANs on your switch.
Step2. Allocate a VLAN ID and IP address for TA400/800.
Step3. Configure VLAN settings page on TA400/800.
VPN Settings
A virtual private network (VPN) is a method of computer networking typically using the
public internet that allows users to privately share information between remote
locations, or between a remote location and a business' home network. A VPN can
provide secure information transport by authenticating users, and encrypting data to
prevent unauthorized persons from reading the information transmitted. The VPN can
be used to send any kind of network traffic securely. TA400/800 supports OpenVPN.
To Next Page
Loading...
Need help?
General
