TA400/800 User Manual
22/64
Table 5-4 Description of SIP General Settings
Port used for SIP registrations. The default is 5060.
Enable or Disable Random SIP port.
Random Port Update
Interval
Set the Random Port Update Interval.
Port used for SIP registrations. The default is 5060.
Port used for SIP registrations. The default is 5061.
When using TA FXS Gateway as a TLS client, whether
or not to verify server’s certificate. It is ―No‖ by default.
When using TA FXS Gateway as a TLS server, whether
or not to verify client’s certificate. It is ―No‖ by default.
Set this parameter as ―No‖, then common name must be
the same with IP or domain name.
When using TA FXS Gateway as TLS client, specify the
protocol for outbound TLS connections. You can select
it as tlsv1, sslv2 or sslv3.
Beginning of the RTP port range.
End of the RTP port range.
Set the default mode for sending DTMF. Default setting:
rfc2833
Max
Registration/Subscription
Time
Maximum duration (in seconds) of a SIP registration.
The default is 3600 seconds.
Min
Registration/Subscription
Time
Minimum duration (in seconds) of a SIP registration.
The default is 60 seconds.
Default Incoming/Outgoing
Registration Time
Default Incoming/Outgoing Registration Time: the
default duration (in seconds) of incoming/outgoing
registration.
The number of SIP REGISTER messages to send to a
SIP Registrar before giving up. The default is 0 (no
limit).
Number of seconds to wait for a response from a SIP
Registrar before classifying the register has timed out.
The default is 20 seconds.
Calling Channel Codec
Priority
Once enabled, when dialing out via SIP/SPS trunks, the
codec of calling channel will be selected preferentially. If
not, TA FXS Gateway will follow the priority order in
your SIP/SPS trunks.
Support SIP video or no. The default is yes.
Configure the max bit rate for video stream. The default:
384kb/s.
Please enable this option when your SIP trunk contains
To Next Page
Loading...
Need help?
General
