2.8 Dividing and Generating the Source Values
Procedure
Setting the Number of Divisions
1.
With the source value and measurement value displayed, press SETUP under Function 2.
2.
Use the cursor keys to select Function2 Common Setup, and then press ENTER.
3.
Use the cursor keys to select the Division Number value, and then press ENTER. The settings
are displayed at the bottom of the screen.
4.
Use the arrow keys to set the number divisions from the 0% value to the 100% value, and press
ENTER.
When the source range is 1-5V, 1-5V√, 4-20mA, 4-20mA√, or 4-20mA Simulate, the number
divisions is fixed to 4.
5.
Press the arrow key corresponding to EXIT SETUP. The settings are confirmed, and a screen
appears showing the source value and measurement value.
The cancel the settings, press ESC to return to the screen and step 2.
To initialize the settings, pressing the arrow key corresponding to INIT SETUP.
Turning the Source On and Off
6.
With the source value and measurement value displayed, press OUTPUT ON/OFF.
The displayed source value is output, and OUTPUT:OFF on the screen changes to
OUTPUT:ON.
To turn off the source, press OUTPUT ON/OFF again.
Increasing or Decreasing the Source Value
7.
Press UP or DOWN. The source value increases or decreases by the specified division width.
Note
You can change the source value to the 0% or 100% value by pressing the 0% or 100% key.
2-18
IM CA500-01EN
To Next Page
Loading...
Need help?
General
