To Next Page
C
colleen35Aug 7, 2025
What to do if no confocal images are confirmed on my YOKOGAWA Scanner?
- GGina GilbertAug 7, 2025
If you are not getting any confocal images, consider these potential causes and solutions: * **No laser beam incident from the objective lens:** Turn on the key switch (Green LED), switch the microscope light path to the camera port, select the through (no DM) block in the microscope, remove the DIC polarizer, and turn on the laser system. * **Light path is at the 2nd port:** Push the knob and switch to the 1st port. * **Laser is too weak:** Power up the laser. * **Microscope illumination is ON:** Turn down the illumination. * **Camera is not working:** Inspect the camera following its instruction manual.
General