-34-
6.5 Command List
Table 6-5-1 Command List
Main Item Detailed item Function Command
CSU control Shutter Open shutter SHO
Close shutter SHC
Acquire shutter status SH, ?
Acquire open/close count SH_CNT, ?
Disk Assign disk rotation speed [rpm] MS, [n]
Fine adjustment of disk rotation
speed to increase
MS+
Fine adjustment of disk rotation
speed to decrease
MS-
Acquire disk rotation speed [rpm] MS, ?
Acquire upper limit of disk
rotation speed [rpm]
MS_MAX, ?
Automatic adjustment to camera
exposure time [ms]
MS_ADJUST, [f]
Run disk rotation MS_RUN
Stop disk rotation MS_STOP
Dichroic mirror Assign dichroic mirror position DM_POS, [n]
Acquire dichroic mirror position DM_POS, ?
Filter Wheel control Assign Filter Wheel position FW_POS, [ch], [n]
Acquire Filter Wheel position FW_POS, [ch], ?
Bright Field control Bright Field
Move Bright Field port to the
original point
BF_INIT
（ Port switching
control）
Switch port to confocal position BF_OFF
Switch port to Bright Field
position
BF_ON
Acquire current position BF_POS, ?
Port Assign Port position PT_POS, [ch], [n]
Acquire Port position PT_POS, [ch], ?
External ＩＯ control General purpose ＩＯ
Assign output terminal level EO, [ch], [n]
Acquire appointed level of
output terminal
EO, [ch], ?
Acquire input terminal level EI, [ch], ?
General purpose
DA
Set DA output parameter DA_DATA, [ch], [n]
General purpose
DA
Set DA output parameter DA_DATA, [ch], [n]
General purpose
AD
Acquire AD input value AD_DATA, [ch], ?
Memory control Save memory Save parameters SAVE_MEM
Save Filter Wheel information
(max.16 letters)
FW_INFO, [ch], [n] “XＸＸ
X”
Save dichroic mirror information
(max. 16 letters)
DM_INFO, [n], “XXXX”
Memory load Load parameters from memory L LOAD_MEM
Load default parameter LOAD_INIT
To Next Page
Loading...
General