-39-
3.3.5 Installation of Camera
Please follow the user's manual of your camera when you mount it on the CSU-X1
using the C-mount adapter. Insert the C-mount adapter fixed to the camera into the
camera port adapter on the unit. Use the M3 screws to fix the camera adapter with
the Allen wrench provided.
CAUTION
The body of the CSU-X1 is durable up to 5 kg. If you install a camera heavier than 5
kg on the CSU-X1, please use an appropriate support to fix the camera so that the
CSU-X1 will not be deformed.
When you install the CSU-X1 to the side port of an inverted microscope and mount a
camera horizontally, please support the camera to prevent deformation of the
camera adapter.
When you install the system onto an upright type microscope and total weight of
confocal system including CSU-X1, its accessories including a camera surpassed
microscope’s maximum weight tolerance, it is necessary to support total system.
Please inquire your local sales representative.
3.3.6 Power Switch
z Control Unit
Please confirm if the control unit Interlock key is inserted into EXT
INTERFACE1/I.LOCK at the backside of the control unit. If not, please insert
supplied key. Also, please confirm if CSU-X1 and the control unit is connected
with supplied cable. And then, put the power of the control unit ON.
z CSU-X1
(1) Model without a control unit:
Please insert CSU-X1 Interlock key into EXT CONTROL / INTERLOCK
connector before put ON the power. The interlock is unlocked, enabling you to
manually open/close the shutter from the operation panel.
(2) Model with a control unit: CSU-X1CU-F1
Shutter control via panel switch or control unit becomes possible after CSU-X1
power is ON.
To Next Page
Loading...
General