7-12
IM CW120-E
7.2.7 Setting Output Interval ( )
Description
When saving (outputting) data in the electric energy measurement mode, the
interval of saving (outputting) data needs to be set. This output interval is set
to 30 minutes by default and can be selected from:
1, 2, 5, 10, 15, and 30 seconds,
1, 2, 5, 10, 15, and 30 minutes, and
1 hour.
Procedure
(1) Using the keys in the setting item selection screen, make the
mark and the current interval setting appear on the screen. Then,
press the
key. The current setting flashes.
DISP
ENTER
MEAS/SET
ESC
MEAS/SET key
Interval
UP/DOWN/LEFT/RIGHT keys
ENTER key
Output Interval Setting Screen
ESC key
7.2 Setting Each Item
To Next Page
Loading...
