2-5
IM 701610-61E
SPI Bus Signal Analysis Function
2
2.3 Displaying the Signals to Be Analyzed
Setting the Hysteresis
Sets a width to the trigger level so that triggers are not activated by small changes in the
trigger signal.
: Approximately 0.3 divisions
*
of hysteresis around the trigger level.
: Approximately 1 divisions
*
of hysteresis around the trigger level.
* The value above is an approximate value. It is not strictly warranted.
Setting the Hold Off Time
Selectable range: 80 ns to 10 s (the initial value is 80 ns)
Resolution: 20 ns
For details, see section 6.4, “Setting the Hold Off Time” in the
DL1620/DL1640/DL1640L
User’s Manual IM 701610-01E
.
To Next Page
Loading...
