1-4
IM 701610-61E
• When ADRS Is Selected
5. Press the Adrs&Data soft key. The I2C Adrs&Data Setup dialog box appears.
Setting the Address Pattern
6. Turn the jog shuttle to select Address Pattern.
7. Press SELECT. The button to the left of Address Pattern is highlighted, and the
address pattern becomes the trigger target.
8. Turn the jog shuttle to move the cursor to the item you wish to set the pattern.
9. Press SELECT to display the entry box.
Entry box
10. Turn the jog shuttle to set the value. Bits set to “X” will not be used as a trigger
condition. The trigger conditions can be specified using binary (BIN) or
hexadecimal (HEX) values.
Press SELECT or ESC to close the entry box. The value will be confirmed.
1.3 Setting the Trigger Conditions
To Next Page
Loading...
