YOKOGAWA MY600 - Page 25

22
IM MY600-01EN
• Topreventmistakesinoperation,anemptyrangeis
providedbetweenthe500Vand1000Vrangesofthe
range switch.
• Intermittentwarningbuzzersoundswhentherange
switchissetto1000Vrange.
• Holdfunction
A measured insulation or low-resistance value is held
and displayed until the range is changed or another
measurement is started.
• 0Ωadjustmentfunction
In low-resistance measurements, the resistance of the
cordandfusecanbecancelleduptoabout3Ω.
• Elapsedtimedisplay
The measurement time is displayed upon starting an
insulation resistance measurement.
• One-minutevaluedisplay
The measurement 1 minute after starting an insulation
resistance measurement can be displayed.
• DielectricAbsorptionRatio(DAR)/PolarizationIndex(PI)
measurement
DAR and PI values are calculated automatically during
an insulation resistance measurement.
• Memoryfunction
Measured data can be saved, loaded, and deleted from
the internal memory.
• Communicationfunction
Data saved in the internal memory can be transferred to
a PC using communication.
• Clock
Measured data is saved with the measurement time
information.