29
IM MY600-01EN
3. Component Names and Functions
Front Panel
1
2
3
4
6 7 8 9 10 11
5
No. Name Function
1 LCD LCD with backlight
2 Illuminance
sensor
Detects ambient brightness and automatically
turns on or off the lights.
3 Measurement
switch
Press this switch to place the instrument in
a measurement ready state. Then, press the
probe’s remote switch to start a measurement.
If you release the measurement switch,
measurement is not possible even when you
press the probe’s remote switch.
Turning the measurement switch clockwise
while holding it down locks the switch. In this
state, you can measure simply by pressing
the probe’s remote switch.
4 Comm. port You can connect a 91030 USB communication
adapter, and transfer saved data to the PC.
5 Memory key Press shortly (less than 1 s) while
measurement is held to save the measured
values. Hold down (1 s or more) while the
instrument is in standby mode to read or
delete saved data.
6 Arrow keys Increase or decrease settings.
To Next Page
Loading...
Need help?
General
