YOKOGAWA MY600 - Page 58

55
IM MY600-01EN
How to Turn the Functions On and Off
1.
In standby mode with the measurement function set to
anything other than low-resistance, hold down SETUP
for at least 2 seconds. The instrument changes to
configuration mode.
2.
Press the arrow keys to show the backlight and buzzer
setup screen. The following figures show the different
setup screens.
Backlight setup screen:
The screen shows bL.
Buzzer setup screen:
The screen shows .
Blinking
Blinking
3.
Each time you press ENTER, the setting changes
between on and off. The current setting is shown as “on”
or “oFF” on the screen.
4.
Press ESC. The setting is saved, and the instrument
returns to standby mode. (The setting is retained even
if you turn off the power.)