YOKOGAWA PH202G (S) - 5-1-4. Manual Impedance Check; Initiating a Manual Impedance Check Procedure

IM 12B6C3-E-E
5-5 Parameter setting
5-1-4. Manual impedance check
12B6C3-36
NO
YES
pH
AUT.CAL
YES
NO
pH
MODE
NO
NO
NO
NO
YES
pH
YES
NO
NO
YES
pH
5-1-4. Manual Impedance Check
Return to measuring
mode after updating
impedance chec
k
Note: The manual impedance start
is available when the sensor impedanc
e
measurement is enabled in Service
Code 3 and 4.
This enables the impedance data to be
updated immediately after a maintenance
event (e.g. replacing an
electrode).
YES
MODE
pH
OUTPUT
SET HOLD
SERVICE
ENT
NO MODEYES
YOKOGAWA
MEASURE