How to fix E1 error on YOKOGAWA SC202G?
If the YOKOGAWA Transmitter displays error E1, it might be due to a fouled sensor surface or excessively high conductivity. Try cleaning the sensor and then calibrate it. If the issue persists, consider replacing the sensor.
What to do if my YOKOGAWA SC202G Transmitter shows E5 error?
If the YOKOGAWA Transmitter displays error E5, it could be due to incorrect wiring, internal leakage of the sensor, or a defective cable. Check the wiring (3-5). If the problem continues, replace the sensor or the cable.
Why is my YOKOGAWA Transmitter showing error E6?
If the YOKOGAWA Transmitter displays error E6, it might be caused by a dry sensor, incorrect wiring, or a defective cable. Immerse the sensor, check the wiring (3-5), and if necessary, replace the cable.
What causes E7 error on YOKOGAWA SC202G and how to fix it?
If the YOKOGAWA Transmitter is showing error E7, it may be caused by the process temperature being too high or too low, the wrong sensor being programmed, or incorrect wiring. Check the process temperature, the sensor model code, and the connections and cable.
How do I troubleshoot error E8 on a YOKOGAWA Transmitter?
If the YOKOGAWA Transmitter displays error E8, it may be caused by the process temperature being too high or too low, the wrong sensor being programmed, or incorrect wiring. Check the process temperature, the sensor model code, and the connections and cable.
What does error E15 mean on my YOKOGAWA SC202G Transmitter?
To address error E15 on your YOKOGAWA Transmitter, inspect the cable, clean and reterminate the connections, and reprogram the device. The error could be caused by high cable resistance, corroded contacts, or a wrongly programmed sensor.
How to resolve E2 error on YOKOGAWA SC202G Transmitter?
If you encounter error E2 with your YOKOGAWA Transmitter, it may be due to incorrect field calibration of TC. Readjust or set calculated TC.
What should I do if my YOKOGAWA SC202G Transmitter shows error E3?
If the YOKOGAWA Transmitter displays error E3, it means the calibrated value differs more than +/- 20 % of the nominal value programmed in code 03. Check for the correct sensor and the correct unit (?S/cm, mS/cm, k?·cm or M?·cm). Repeat calibration.
What does E4 error mean on YOKOGAWA SC202G Transmitter?
If your YOKOGAWA Transmitter shows error E4, it means that wrong data was entered in the 5x5 matrix. Reprogram the device.
Why does my YOKOGAWA SC202G display error E9?
If you're seeing error E9 on your YOKOGAWA Transmitter, it's likely due to excessively high zero caused by cable capacitance. Replacing the cable should resolve this issue.
Describes the main function of the transmitter, conductivity or resistivity measurement.
Provides an overview of the product and its general description.
Describes the EXA operator interface and access to different operation levels.
Details the commissioning mode for setting up the transmitter for specific applications.
Explains the conditions that necessitate calibration of the instrument.
Outlines the minimal periodic maintenance required for the EXA 202 transmitter.
Explains the diagnostic checks performed by the EXA SC202.
Details the physical aspects of installation and the transmitter's dimensions.
Details the procedure for setting up passcode protection for the instrument.
Details specific functions accessible via service codes.
Details user settings for non-linear output tables using codes 31 and 35.
General| Brand | YOKOGAWA |
|---|---|
| Model | SC202G |
| Category | Transmitter |
| Language | English |
To Next Page