YOKOGAWA SC202G - Service Code

IM 12D08B02-01E
Parameter setting 5-7
5-2-6. Service code
The figure below shows a typical button sequence to change a setting within the service menu. The
specific settings are listed in numerical sequence on the following pages. On the page facing the setting
tables are concise explanations of the purpose of the service codes.
Example: Service Code 01
Select main parameter
for SC
for RES
With the >, ,ENT keys
>
ENT
After changing the parameter,
the instrument first goes into
reset to load the parameter
specific default values.
MODE
MEASURE
CAL
DISPLAY
HOLD
OUTPUT
SET HOLD
TEMP.
SERVICE
YES
ENT
NO
NO
NO
NO
NO
ENT
ENT
ENT
ENT
ENT
YES NO
YES NO
YES NO
YES NO
YES NO
mA
mA