<Toc> <2. Initial Settings>
2-7
IM 05D01B02-41E
NOTE
The controller may automatically initialize the registered operating parameter setpoints if
any change is made to the data item PV Input Type (IN1), Maximum Value of PV Input
Range (RH1), Minimum Value of PV Input Range (RL1), PV Input Decimal Point Position
(SDP1), Maximum Value of PV Input Scale (SH1) or Minimum Value of PV Input Scale
(SL1). After a change has been made to any of these data items, be sure to verify the
registered operating parameter setpoints to ensure that they are correct. If any data item
has been changed to its default, set it to a required value.
How to return to a menu
Press
DISP
key once during parameter setting. This lets you return to the parameter
menu.
1st Edition : May 31,2000-00
To Next Page
Loading...
Need help?
General
