YOKOGAWA UT750 - Page 39

<Toc> <2. Initial Settings>
2-17
IM 05D01B02-41E
2.
Press the
SET/ENT
key for more than 3 seconds
to call up the main menu “MODE”.
mode parameter
main menu
MODE
A/M
DISP
SET/ENT
3.
Press the key once to display the main
menu “STUP”.
password input
main menu
STUP
A/M
DISP
SET/ENT
4.
Press the
SET/ENT
key once to display the main
menu “LOOP1”.
loop 1 setup para
SETUP main menu
LOOP1
A/M
DISP
SET/ENT
5.
Press the
SET/ENT
key once to display the
submenu “SP”.
SP control
SETUP sub menu
SP
A/M
DISP
SET/ENT
6.
Press the key once to display the
submenu “ALM”.
alarm control
SETUP sub menu
ALM
A/M
DISP
SET/ENT
7.
Press the
SET/ENT
key once to display the
parameter “AL1” (alarm-1 type).
SETUP
A/M
DISP
SET/ENT
MENU:LOOP1/ALM #1
alarm 1 type select
AL1 = 1
8.
Press the or key to display the
required setpoint. The figure below shows
an example of setting the PV low limit
alarm.
MENU:LOOP1/ALM #1
changing
alarm 1 type select
AL1 = 2
A/M
DISP
SET/ENT
Blinks during
change.
9.
Press the
SET/ENT
key once to register the
setpoint.
SETUP
A/M
DISP
SET/ENT
MENU:LOOP1/ALM #1
alarm 1 type select
AL1 = 2
You can take the same steps for alarm-2
type (AL2), alarm-3 type (AL3), and alarm-4
type (AL4) that are displayed after this.
10.
Press the
SET/ENT
key for more than 3 seconds.
This returns you to the display shown at
power-on (figure below).
A/M
DISP
SET/ENT
SP :1.
-10 0 +10
0.0°C
DV
11.
When setting alarm setpoints, see “3.5
Setting Alarm Setpoints.”
1st Edition : May 31,2000-00