5.7 Error code display
If there is a fault occurs in the electronic system of the electric bicycle, the display will automatically show an error
code, see Schedule 1 for a detailed definition of the error code.
Figure 5-6 Error Code Display
6. Personalized Parameter Settings
Each setting needs to be done with the bicycle stationary.
The personalized parameter setting procedure is as follows:
When the display is ON and the speed shows 0,
(1) Press and hold simultaneously for more than 2 seconds to enter the personalized parameter setting
interface.
(2) Press / to toggle between the personalized parameter setting interface, and press to enter the
parameter changing state.
(3) Press / to select the parameter, long pres for addition operation, long press for subtraction
operation.
(4) Press to save the parameter settings and return to the personalized parameter setting interface.
(5) Long Press to save the parameter settings and exit the personalized parameter setting interface.
The following options are available on the personalized parameter setting interface:
When the error code appears on the display,
please troubleshoot the problem in time, the
electric bicycle will not be able to drive
normally after the problem occurs.
To Next Page
Loading...
