JOHNSON CONTROLS
24
FORM 155.31-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
MOVING THE MACHINE ON ROLLERS
Plan the entrance of the machine.
Do not incline the machine more than 10 degrees. If
the machine has to be inclined more than 10 degrees,
the solution and refrigerant will need to be extracted
beforehand.
Use care not to apply shock to the machine. The ma-
chine is a high-vacuum vessel containing a corrosive
solution. Use diligence in protecting the machine as
repair is labor intensive and costly.
When a skid base is used to move the machine on roll-
ers, secure the skid base and place the machine legs
evenly on the skid base before moving the machine on
rollers.
FIGURE 5 - MOVING THE MACHINE ON ROLLERS
LD22946_UL
7.86
3.93
Skid base
Approximately 3.93
Approximately 3.93
7.86
To Next Page
Loading...
