JOHNSON CONTROLS
29
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
FORM 155.31-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
3
VIBRATION AND ISOLATION DETAILS
Before you install the unit, fit rubber vibration isolators
to the unit base as shown in Figure 9 on page 29.
Use liners to adjust the levelness of the unit. For unit
dimensions, see Table 7 on page 38, Table 8 on page
39. Table 9 on page 40, and Table 10 on page
41.
LD19979
Nut
Nut
Foundation Bolt
Base
Rubber Vibration
Isolator
Rubber Vibration
Isolator
Filling with
Mortar
Washer
Washer
Foundation
Bolt
Sole Plate
Sole Plate
FIGURE 9 - VIBRATION AND ISOLATION DETAILS
To Next Page
Loading...
