JOHNSON CONTROLS
25
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
FORM 155.31-ICOM2.EN.UL
ISSUE DATE: 12/21/2018
3
If using a tir roller to move the machine, fit the tir roller
set to each of the four holes shown in the figure below.
LD22947
Hole (Ø22) for Fitting Tir Roller Set
Anchor Bolt Hole
Tir Roller Set
Tir Roller Set
FIGURE 6 - MOVING THE MACHINE ON TIR ROLLERS
FIGURE 7 - JACK-UP PROCEDURE
JACK UP PROCEDURE
When jacking the machine, be sure to fit the jack in
each of the jack-up supports as shown below.
Jack-up
Support
Machine Base
Jack
Jack-up
Support
Jack-up
Support
Jack-up
Support
Jack-up
Support
To Next Page
Loading...
