SECTION 8 - MICROPANEL
JOHNSON CONTROLS
159
Form 201.28-NM1.1
Issue date: 08/06/2021
8
the (ENTER) key. The cursor will then move to the
AM/PM selection. The meridian (AM/PM) value may
ARROW) keys and entered by pressing (ENTER)
key. Repeat this process for the STOP time. Once a
schedule is entered, the schedule for the next day will
appear. The start and stop time of each day may be pro-
grammed differently.
To view the schedule without making a change, sim-
ply press the SCHEDULE key until the day you wish
backwards to the previous screen.
If at any time the schedule is changed for
Monday, all the other days will change to
the new Monday schedule. This means if
the Monday times are not applicable for
the whole week, then the exceptional days
would need to be reprogrammed to the
desired schedule.
To program the chiller for 24 hour operation, program
the start and stop times of each day of the week for
00:00.
After the SUN (Sunday) schedule appears on the dis-
ARROW) key will display the Holiday schedule. This
is a two-part display. The first reads:
SCHEDULE UNIT OPERATING
HOL START = 00:00 AM STOP = 00:00 PM
The holiday times may be set using the same procedure
as described above for the days of the week. Be sure to
press the (ENTER) key after setting the START and
STOP times to save the change in memory. Pressing
the SCHEDULE key a second time, the display will
show the individual days:
SCHEDULE UNIT OPERATING
S M T W T F S HOLIDAY NOTED BY *
The line below the empty space is the cursor and will
pressed. To set a day for the Holiday Schedule, the cur-
sor must be moved to the space following the day of
the week. The * key is then pressed and an “*” will
appear in the space signifying that day as a holiday.
The Holiday schedule must be programmed weekly. If
there is no holiday, the “*” key is also used to delete the
“*”. The (ENTER) key is used to accept the holiday
schedule for the entire week.
The HOLIDAY SCHEDULE is a tem-
porary schedule. Once the schedule is
executed, the selected holidays will be
cleared from memory for the following
week.
Sound limit schedule
The SOUND LIMIT SCHEDULE allows setting the
day and time when the user desires using the “SILENT
NIGHT” factory programmed option to limit chiller
loading and fan operation for reduced audible noise in
the surrounding area. If the SOUND LIMIT SCHED-
ULE is selected under the CHOOSE SCHEDULE dis-
play, the following message will appear:
SCHEDULE SOUND LIMIT = XXX %
MON START = 06:00 AM STOP = 10:00 PM
The Sound Limit option can be enabled and disabled
once each day or the chiller can be set to run continu-
ously in this mode for sound limiting whenever the
chiller is operating. When sound limiting is enabled,
the unit will be limited by the Sound Limit setpoint
% as set under the PROGRAM key. XXX in the dis-
play above will show the Sound Limit Setpoint % pro-
grammed under the PROGRAM key. 0% will cause no
speed reduction, while 100% only allows running at
minimum speed.
The START Time for a specific day (hour and minute)
is entered using the same guidelines used for the start/
stop schedules, and press the (ENTER) key to store
it into memory. The cursor will then move to the AM/
PM selection.
pressing (ENTER) key to store the value.
This process is repeated for the STOP time.
Once the schedule for a specific day is programmed
and entered, the schedule for the next day will appear.
The schedule for each day may be programmed the
same or differently.
To view the schedule without changing it, simply press
key will scroll backwards to the previous screen.
To Next Page
Loading...
