York YVAA Style A - Unit Rigging Specifications (Continued); Rigging Hole Locations (Continued)

SECTION 3 - RIGGING, HANDLING, AND STORAGE
JOHNSON CONTROLS
29
Form 201.28-NM1.1
Issue date: 08/06/2021
3
LD18582
Table 1 - Unit rigging (cont'd)
YVAA model
Description Units
Rigging holes
Frame Cond Evap I J K L M N O P
023 3 B
Rigging hole
location
in. 18 60 137 215 272
mm 464 1533 3485 5456 6919
024 5 C
Rigging hole
location
in. 18 60 149 240 324
mm 464 1533 3789 6088 8218
024 8 C
Rigging hole
location
in. 12 73 163 254 347
mm 314 1845 4144 6443 8825
026 3 B
Rigging hole
location
in. 18 60 137 215 302
mm 464 1533 3484 5455 7670
027 3 D
Rigging hole
location
in. 12 73 121 181 264 324
mm 314 1845 3073 4601 6717 8218
027 5 E
Rigging hole
location
in. 12 73 121 181 264 324
mm 314 1845 3073 4601 6717 8218
027 8 E
Rigging hole
location
in. 12 73 121 181 243 347
mm 314 1845 3073 4601 6169 8825
029 5 E
Rigging hole
location
in. 12 73 179 290 347
mm 314 1845 4551 7358 8825
030 3 C
Rigging hole
location
in. 12 73 161 254 347
mm 314 1845 4092 6443 8825
Note: Rigging and lifting the unit must be done safely by a professional rigger as discussed in this section. The rigger should locate the center of
gravity through trial lifts to account for possible variations in unit conguration. Contact your nearest Johnson Controls Sales O󰀩ce for weight data.