15
Main power switch
3.2.2 Emergent stop button
This button is mounted on the right side of the mounting plate of the control cabinet. Press any stop button
to stopping when the emergency appears. All the dynamic power supply of machine will be switched off after you
press the stop button, the machine stay at “stop” status.
Emergent stop button
Attention
After press the stop button, the system will switch off all the dynamic power supply (e.g. machine
power supply and laser power supply), controlled power supply is still electrifying. Necessarily, if
you want to switch off the power supply of the whole machine, you should turn off the switch of
total power supply even pull out the electric cable of total power supply.
You can loosen the stop button and continue to operating only when the emergency has been
removed and all the flaws have been rectified or the breakdown has been restored.
To Next Page
Loading...