32
Chapter6. Transportation, Shipment and Storage
6.1 Packaging
CMA1325C-B-AThe chiller, laser and accessories of CMA1325C-G-A laser cutting machine are packed in
wooden cases. Other parts are wrapped with PE foam and protective film to protect external objects damaging
any part of the laser cutting machine.
6.2 Transport and shipment method and precautions
Do not climb or stand on the crate, or place any heavy objects on the crate.
Do not drag or carry the product with cables connected to the product.
Do not impact or scratch the panel and the display.
The crate should be protected from moisture, exposure in the sun and rain.
When lifting the machine, handle gently to avoid collision. The wire rope shouldn’t scratch the machine
while lifting; if unavoidable, isolate with soft objects.
6.3 Storage conditions, period and precautions
The storage environment of the machine should avoid the rain, moisture, inclining, rodents, potholes and
other hazards and ensure good ventilation. The storage ambient temperature should be -10°C ~ +40°C, and
relative humidity is not higher than 85%. For the transport and storage less than 24 hours, the ambient
temperature shouldn’t exceed 60°C. It is prohibited to store in open air for a long time. If temporary storage is
required, in addition to the above requirements, check the storage conditions and packaging state to ensure the
machine from damage.
To Next Page
Loading...