30
4.6 Runtime maintenance
Before running the machine tool, check machine tool every day as required. If there is abnormal sound when
the machine tool is running, shut down and check immediately. After the machine is running, shut down in
required sequence, clean the work table of the machine tool and around machine, and do not place unrelated
items on the work table or console of the machine.
① Regularly check the lubrication of the moving parts of the machine tool, ensure sufficient lubrication of
X-axis rail, Y-axis rail, Z-axis rail and screw seat, ensure the accuracy of the machine tool, keep
lubrication of all moving parts and extend the life of X-axis, Y-axis and Z-axis rails;
② Check the air pipe and water pipe for damage weekly; if damaged, inform Han's Yueming Laser for
maintenance;
③ Clean the debris and dust from the air inlet and outlet, and filter screen of the machine tool weekly;
④ Check the level of the cooling water weekly, and fill up in time if insufficient;
⑤ Check the pollution of the reflector and focusing lens surface every two weeks, and clean the optical
lens in time to ensure its service life;
⑥ Check the outer optical path once every month; the optical path directly affects the cutting results;
⑦ Check the filter in the gas path once every month, and remove the water and debris from the filter;
⑧ Regularly check if external cables are scratched, and if the interfaces in the power distribution cabinet
loose;
⑨ After the machine tool is installed and used for six months, readjust the level of the machine tool to
ensure the cutting precision;
4.7 Maintenance of long-term shutdown
If the machine tool will be shut down for long time, please lubricate the moving parts of the machine and
wrap in rust-proof paper. For other parts, regularly check for rusting, process the rusting parts (add dust cover if
possible), regularly clean and check the machine.
To Next Page
Loading...