The Crossover Page
Above, you see the crossover page of a 12-channel system with channels 1/2 highlighted. When you
fill in the I/O page, default crossovers are set for each speaker. On the crossover page you can modify
the default values to match the needs of your particular speakers. There are HIGH PASS and LOW-PASS
filters available for every output channel. Drop-down menus let you choose the Type (SHAPE) of
crossover you wish to use and the SLOPE of the crossover. For the Crossover frequencies you can
highlight a box and type in the frequencies, click in the box and use your keyboard Up/Down, or you
can click on the up/down arrows in the frequency box.
The best source of information about proper crossover choices is always the speaker manufacturer.
They can tell you the best frequency and slope to get the best performance from their products.
Note: There are link buttons on various pages of the GUI, to make identical changes to multiple channels. Blue link
buttons link pairs of channels only, while Green link buttons link any combination of channels.
28
To Next Page
Loading...
Need help?
General
