The revolutionary Zapco HDSP-V Series
From Italy finally comes a masterpiece of engineering that will mark the history of Zapco with a
fundamental step from the analog to the digital world, with everything at the highest levels possible
today in the high-end audio world. It was made for the car, but the performances are so extraordinary
that it's a unique product to use even at home as it can hold up to comparison with home audio
products, which have significantly higher prices.
The new HDSP-V is finally available in its 16 and 8 channel versions. Long-awaited, it has required an
incredibly long work for the development of firmware, software, and hardware. Six Master Engineers
have worked for 3 years on this project with over 15,000 hours of activity. It has been developed for
performance that will set entirely new standards. The noise floor of this device reaches -140 dB (noise
plane without input signal). In the 192 KHz version with player or with digital inputs, the S/N of the
analog outputs is equal to 115 dB in the basic version, or over 130 dB with the DAC A option.
The HDSP-V has only one chipset that integrates two processors that work up to 64 bits and 456 MHz
(for a total of 912 MHz), both for the management of the Player and the DSP. The Player is therefore
completely integrated into the DSP itself. This guarantees the Player a total absence of connection
problems and the transmission of the signal, from the Player's processor to the DSP's processor, within
the same chipset. All up to 192 KHz for a signal line that can reach the new digital Z-AP amplifiers (coming
next year) through an optical SPDIF connection.
The possibilities of connection of the HDSP-V are with its dash remote control or with Wi-fi connection.
HD Bluetooth streaming is possible thanks to the optional module.
Vincenzo Biasella
President
APEX & Zapco
4
To Next Page
Loading...
