Zapi ZAPIMOS HP 350A - Modifying Parameters using the Mini-Console

Pagina 14
4.1 MODIFYING PARAMETERS USING THE MINI-CONSOLE4.1 MODIFYING PARAMETERS USING THE MINI-CONSOLE
4.1 MODIFYING PARAMETERS USING THE MINI-CONSOLE4.1 MODIFYING PARAMETERS USING THE MINI-CONSOLE
4.1 MODIFYING PARAMETERS USING THE MINI-CONSOLE
The parameters that can be modified are:
Lifting Lifting
Lifting Lifting
Lifting
11
11
1 1ST SPEED
22
22
2 2ND SPEED
33
33
3 3RD SPEED
44
44
4 HYDRO SPEED
55
55
5 HYDRO COMP.
00
00
0 NOT CONNECTED
The adjustments are possible within 10 intermediate levels.
- Connect the mini-console to connector (B) on the chopper.
(the hookup MUST BE MADE WITH THE KEY OFF).
- Supply the machine by activating the key.
- Position the dial selector on the function to be modified.
The SET-UP button increases the value of the parameter, while SET-DOWN decreases it.
Note: the variations are made through a count of the number of impulses sent from the
buttons; thus for increasing or decreasing more than one point, you need to release and then
re-press the button.
Keeping the button pressed continuously does not provide continuous variation of the
parameters.
- The parameters are modified in real time, making it possible to check the values set
immediately.
The modified parameters are automatically stored by the control logic without the need for
confirmation before switching off or disconnecting the console.
Important note: The console does not function if connected when the motor is running.
Switch the machine off and on again for activating the console functions.
MENU