15
• Water temperature:water temperature at maximum depth. The measurement range: -5.0 to
40.0(23-104°F). It display ‘Lo’ when water temperature is under -5(23°F). It display ‘Hi’ when water
temperature is over 40.0(104°F).
• User Safety Factor(=USF): When the level is “0” the usual algorithm is used for calculations. When the
level is “1” and “2” the next higher altitude rank is used for calculations. The default setting is “0”.
• Average depth: It is diving average water depth. If depth is over 99.9m(328ft), this
display is ‘---’. In Gage mode,if depth is over 199.9m(656ft), this display is ‘---’.
• Maximum depth: This is the maximum depth recorded during a dive. If depth is over
99.9m(328ft), this display is ‘---’. In Gage mode,If depth is over 199.9m(656ft), this display is ‘---’.
• Ascent rate indicator: This is the maximum Ascent rate recorded during a dive
• Sea/Fresh Icon: This indicates the water setting (sea water/fresh water).
• Gage mode Icon: In gage mode, the Icon is on.
• Mode display: This shows Dive log mode.
• Warnings: These are warnings that can occur during a dive. For further description of these warnings
see the ‘dive mode’ section.
<Ascent rate warning> <Decompression dive>
<Decompression stop violation> <Out of measurement range warning>
SLOW Icon blink
DECO STOP Icon is on
DECO STOP Icon blink
All segment blink
To Next Page
Loading...
