EasyManuals Logo

Zebra TC56 Integrator Guide

Zebra TC56
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #79 background imageLoading...
Page #79 background image
DataWedge 3 - 11
Figure 3-11 Data Capture Panel Settings
Enable - Select to enable Data Capture Plus (default - disabled).
Dock button on - Select position of the button.
Left or right - Allows user to place the button on either the right or left edge of the screen.
Left only - Places the button on left edge of the screen.
Right only - Places the button on the right edge of the screen.
•Start in - Select the initial DCP state.
Fullscreen mode - DCP covers the whole screen.
Button mode - DCP displays as a circular button on the screen and can be switched to fullscreen mode.
Button only mode - DCP displays as a circular button on the screen and cannot be switched to fullscreen
mode.
Button highest position - Select the top of the range the user is allowed to move the DCP, given as a
percent of the screen height (default - 0).
Button lowest position - Select the bottom of the range the user is allowed to move the DCP, given as a
percent of the screen height (default - 100).
Drag detect time - Select the time in milliseconds that the scanner waits before activating scanner. This
allows the user to drag the button without initiating scanner (default - 100 ms, maximum 1000 ms).
In Button mode, the user can place DCP in full screen mode by dragging the button over Fullscreen mode. The
overlay covers the screen.
NOTE The DCP does not appear if the scanner is disabled in the profile even though the Enabled option is set.

Table of Contents

Other manuals for Zebra TC56

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra TC56 and is the answer not in the manual?

Zebra TC56 Specifications

General IconGeneral
Display diagonal5 \
Touch technologyDual-touch
Touchscreen typeCapacitive
Display resolution1280 x 720 pixels
Flash memory0.016 GB
Internal memory0.002 GB
Internal memory typeRAM
Compatible memory cardsMicroSD (TransFlash), MicroSDHC
Maximum memory card size128 GB
Processor familyQualcomm
Processor frequency1.8 GHz
Operating system version6.0
Operating system installedAndroid
RFID reader-
CertificationWFA (802.11n, 802.11ac, WMM-AC, Voice Enterprise, WMM-PS), Miracast WFA (Mobile AP / Personal Hotspot)
Product colorBlack, Silver
Linear (1D) barcodes supportedCode 39
International Protection (IP) codeIP67
Battery capacity4300 mAh
Data networkCDMA, EDGE, GPRS, GSM, HSPA, HSPA+, LTE, UMTS
Wi-Fi standards802.11a, Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth version4.1
GSM bands supported850, 900, 1800, 1900 MHz
Security algorithmsAES, EAP-TTLS, FIPS 140-2, LEAP, MSCHAPv2, PEAP, TKIP, WEP, WPA, WPA2, WPA2-Enterprise
WCDMA bands supported850, 1900 MHz
Second cameraNo
Rear camera resolution (numeric)13 MP
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)-20 - 50 °C
Operating relative humidity (H-H)5 - 95 %
Weight and Dimensions IconWeight and Dimensions
Depth155 mm
Width75.5 mm
Height18.6 mm
Weight249 g

Related product manuals