VCR Menu Settings
Set the Current Time
Set the clock on the front of the VCR in the mes-
sage center. Use the VCR remote control to
show the on-screen display on your TV screen.
1. Press MENU on the remote control. The Main
Menu (VCR Features) appears on your TV
screen.
2. Press I on the remote control.
This will bring you to sub-menu DATE SET.
Set the Month
The first two numbers would be the month. Enter
the month by number; use the numbered keys on
the remote control.
For example April, the 4th month of the year,
would be entered as 04, December the 12th
month of the year would be entered as 12. If you
make an obvious mistake the on-screen display
will show a ? where the correct number should
be. Press ADJ to erase errors.
Programming Tip: If you are having difficulties
press QUIT, then re-enter the Main Menu by
pressing MENU on the remote control to start
over.
Set the Date
The next two numbers would be the date. For ex-
ample 03 would be the 3rd day of November. The
last 2 numbers are the year. For example, 1994
would be entered as 94.
Set the Time
Enter the hours, then the minutes then press
AM/PM on the remote control to choose AM or
PM. For example 9:35 in the morning would be
entered as 09 35 AM.
Receiving VHF/UHF TV Programs or Cable
TV Service
Select Channel 3 on your TV to receive televised
programs from the VCR Tuner.
Press MENU on the remote control to bring up
the Main Menu (VCR Features) on the TV
screen.
Press 4 to choose TUNING FEATURES.
Press 1- Tuning Band. The on-screen menu for
TUNING BAND appears.
Press ADJ to choose TV if you only receive
UHF/VHF CHANNELS. Choose CATV if you
have cable service.
Press SELECT to move to sub-menu AUTO
CHANNEL SEARCH.
VCR Tuner Channel Search
Press ADJ to begin the VCR automatic channel
search program. The VCR searches for the avail-
able channels you receive in your local broadcast
area. When the search program is complete the
channels that were found will be indicated as
CHANNELS FOUND and be followed by the
number of channels that were found. For ex-
ample, CHANNELS FOUND 14.
The VCR has automatically programmed itself to
receive those channels. Press QUIT on the
remote control; the first channel program will ap-
pear on your TV screen.
Note: Make sure you have chosen ON from the
VCR On-Screen Display sub-menu so that the
channel number will appear momentarily in the
upper right hand corner of the TV screen each
time you change channels.
As you press CHANNEL UP or DOWN each
channel the VCR has found will be shown on the
TV screen and the channel number will also be
shown in the VCR message center.
Some Channels may be too weak to send a picture
(adequate viewing signal) to the VCR.
To eliminate these channels in the channel
memory sequence that the VCR has tuned, write
down the numbers of these "weak" channels and
proceed as follows.
Channel Save/Skip
1. Press MENU on the remote control.
2. Choose main menu item 4-TUNING FEA-
TURES.
2609-o 5 -- 2
To Next Page
Loading...
