Timer Recording
=
1
3.
=
/ \
POwer
U
C-iT--')
Turn the TV on and tune to Channel 3.* (If you have a
Zenith TV use the remote control, press 3, then
ENTER.) *See Footnote at the bottom of page 6-1.
Change the remote control to VCR mode.
Insert a VHS tape into the VCR tape loading compart-
ment. If this is a new tape it will be cued to start at the
beginning; if this is a previously recorded tape advance
or rewind the tape to the position where you want to
begin recording.
Press MENU on the remote control to bring up the
Main Menu (VCR Features).
Press 2 to bring up Program Record. Follow the on-
screen instructions, and enter the recording informa-
tion for Program 1.
5. Press 3 to bring up Program Review, check for ac-
curacy what you entered for program 1. (See page 9-2.)
Note: The clock must be set to the current time to have
the program recorded at the right time.
6. Enter the information for Program 2; if there is one.
Check Program 2 information for accuracy, etc.
7. When programming is complete press QUIT then
TIMER on the remote control to set the VCR in Timer
mode; the VCR will remain off until recording time.
Note: While the VCR is operating in the Timer mode it
cannot be turned on or off manually, and other fea-
tures available in other modes like, PAUSE and STOP,
will _not be available.
®®
® ( -,- )
04rF OI4
-(3
FI.A_QK
CHANNEL
VOLUME
M/TIE
RECORD STOP PAUSE Sr:.ARCH
REW _ F FWD TV/VCR
_-o 9 -- 1
To Next Page
Loading...
